Any way to disable the serial port message "Switched to AP Mode xxxxxx\r\nIP address: 192.168.4.1\r\n

If doesn't fit into any other category ....
Post Reply
Palm Liu
Posts: 47
Joined: Fri Jun 25, 2021 3:50 am
Has thanked: 10 times
Been thanked: 17 times

Any way to disable the serial port message "Switched to AP Mode xxxxxx\r\nIP address: 192.168.4.1\r\n

Post by Palm Liu »

As I use ESP-12F hardware serial port (D1 & D3) to communicate another controller. After a while on power up, there is the following message on serial port even I disable WIFI (by WIFI.SLEEP):

\nSwitched to AP Mode xxxxxx r\nIP address: 192.168.4.1\r\n

As this message may sometimes block the communication between ESP-12F & the controller.

Thanks!
Top
Post Reply

Return to “General”