The annex_radio is a simple webradio without a display but easy to built.
All you need:
[Local Link Removed for Guests]
solder that things together like this:
[Local Link Removed for Guests]
[Local Link Removed for Guests]
[Local Link Removed for Guests]
[Local Link Removed for Guests]
[Local Link Removed for Guests]
annex radio
Re: annex radio
this is the code:
[Local Link Removed for Guests]
[Local Link Removed for Guests]
You do not have the required permissions to view the files attached to this post.
Re: annex radio
the Webpage:
[Local Link Removed for Guests]
[Local Link Removed for Guests]
You do not have the required permissions to view the files attached to this post.
Re: annex radio
the config-page and the advanced-settings:
[Local Link Removed for Guests]
[Local Link Removed for Guests]
[Local Link Removed for Guests]
[Local Link Removed for Guests]
You do not have the required permissions to view the files attached to this post.
Re: annex radio
i replaced the board in this usb-speaker:
You do not have the required permissions to view the files attached to this post.
Re: annex radio
tip1 -> do not connect the 3.3V from the ESP-board to the sd-pin on the amp-board
tip2 -> i use a double-side-glue-tape 1mm to bring a little gap between the two boards
tip2 -> i use a double-side-glue-tape 1mm to bring a little gap between the two boards
Last edited by coolj on Thu May 02, 2024 4:57 pm, edited 1 time in total.
Re: annex radio
i forgot the description
1. you can control the radio direct by the encoder (Volume = turn left/right , skip = push the button)
2. you can control it to the webpage (also add your stations and save them)
3. the radio speaks to you -> on skip the next station
4. if you press and hold the button on poweron you get some info like ip-address and the rssi
1. you can control the radio direct by the encoder (Volume = turn left/right , skip = push the button)
2. you can control it to the webpage (also add your stations and save them)
3. the radio speaks to you -> on skip the next station
4. if you press and hold the button on poweron you get some info like ip-address and the rssi
Last edited by coolj on Thu May 02, 2024 6:18 pm, edited 1 time in total.