Re: Version 1.51.2 to test
Posted: Sun Nov 12, 2023 12:07 am
"the possibility to customize the layout of the editor page as per own tastes"
I'm afraid I don't understand this. I'm working on an ESP32 S2Mini flashed with "Annex32-S2 CAN USB 1.51.2 LFS".
============
Implemented the customisation of the layout (experimental)
These keys are active keys only when clicked before inside the LOG window
- CTRL+SHIFT+F1 - Set Vertical Layout
- CTRL+SHIFT+F2 - Set Horizontal Layout
- CTRL+SHIFT+F3 - Save Layout
- CTRL+SHIFT+F4 - Load Layout
- CTRL+SHIFT+F5 - Reset Layout
=============
When I have clicked on the WLOG window, I don't see that anything happens when I use the CTRL+SHIFT+F# keys. My preferred layout would be as large a code screen as will fit on the left, and everything else on the right. How do I go about doing that? (As may be evident by my asking the question, I did succeed in flashing the S2Mini when I used the correct S2 firmware.)
I'm afraid I don't understand this. I'm working on an ESP32 S2Mini flashed with "Annex32-S2 CAN USB 1.51.2 LFS".
============
Implemented the customisation of the layout (experimental)
These keys are active keys only when clicked before inside the LOG window
- CTRL+SHIFT+F1 - Set Vertical Layout
- CTRL+SHIFT+F2 - Set Horizontal Layout
- CTRL+SHIFT+F3 - Save Layout
- CTRL+SHIFT+F4 - Load Layout
- CTRL+SHIFT+F5 - Reset Layout
=============
When I have clicked on the WLOG window, I don't see that anything happens when I use the CTRL+SHIFT+F# keys. My preferred layout would be as large a code screen as will fit on the left, and everything else on the right. How do I go about doing that? (As may be evident by my asking the question, I did succeed in flashing the S2Mini when I used the correct S2 firmware.)