Introducing Annex Version 1.50.8 and New Websites for Updates and Flashing

[charlie]

I repeat the message sent some days ago. Sorry but you haven't reply...

Hi cicciocb, I decided to use BLE to make a very simple transmission.But as soon as I write the word bluetooth.xxxx ... the system signals Syntax error at line....
BLUETOOTH.POWER 7
BLUETOOTH.SETUP "charlie" , 000001
All give me syntax error
Have I to enable something?

Many thanks
Charlie.

[PeterN]

Good morning Charlie

Did you select and install the appropriate Version of annex32 and not unintended the NoBLE-version?

[Fernando Perez]

On the page [Local Link Removed for Guests] I see that you have duplicated the .bin file for the ESP8266 modules. Actually, they are both version 1.44.2.
And I note that a very important version for me is missing, 1.44.3, which corrected a problem with infrared control. You published it at [Local Link Removed for Guests] - p2245

[Fernando Perez]

Charlie, it seems that you are publishing new messages on the same topic, without letting us know if you have read before (and if they have not worked for you) the solutions proposed by other users.

[cicciocb]

On the page [Local Link Removed for Guests] I see that you have duplicated the .bin file for the ESP8266 modules. Actually, they are both version 1.44.2.
And I note that a very important version for me is missing, 1.44.3, which corrected a problem with infrared control. You published it at [Local Link Removed for Guests] - p2245

Fernando,
I was doing some tests, aiming the support for the esp8266 within the Online Flasher so I just uploaded the 1.44.3

[lyizb]

After successfully using the web flasher to flash several ESP32 D1 Minis in the past several days, including one this morning, I am getting this when trying to flash a new-out-of-the-bag ESP32 D1 Mini and also a new ESP32 S2Mini:

Code: [Local Link Removed for Guests]

Welcome to Annex RDS Web Installer
Connecting...
Connected successfully.
Try hard reset.
[Object.debug:7921] Finished read loop

I've tried many times with and without pressing the RST button. What can I do?

[cicciocb]

Try to hold the boot button during the whole process.

[lyizb]

Thanks for the reply, but no success with that on the ESP32 D1Mini--same "debug" message. (There's only a button labelled "RST".)

I did successfully flash another ESP32 D1Mini after the other one failed, so maybe it was just faulty fresh out of the anti-static bag. Odd that the S2Mini would be the same.

[cicciocb]

You should put the pin GPIO0 to gnd and test again

[lyizb]

Thanks, but same result when GP0 pulled to ground (and kept there, or released). I'll just consider it a duff part. I have 4 working, and several more on order.

Thanks for this terrific firmware, and for your continuing efforts at improving it.