Will Annex32 run on this Pico form factor ESP32 board?
Posted: Tue Sep 27, 2022 5:12 pm
2MB flash, 8MB PSRAM https://www.cnx-software.com/2022/09/26 ... pi-pico-w/
Hi Lizby,
the ESP32-S3 is another chip with a different architecture so the actual annex32 firmware do not runs on it.
However, I implemented the support for this chip as well as for the other chips of the family but I miss the time to finish.
At the same time, the toolkit must be modified as the upload process is different for each chip.
However, the board that you propose do not have enough flash (only 2mb), at least 4mb are required.