Hello,
I just did "Flash firmware only". That worked, so I connected to 192.168.4.1 and set up the Config page as needed with Name and PW for
Station Mode. But the module never connected to the router and went back to AP Mode.
Trying with firmware+data for ESP32 (not CAM) the connection to the router worked immediately.
Is there a hint how to get the the module connected to router with ESP32-CAM firmware ?
Thanks a lot.
Rainer
ESP32-CAM flash
- PeterN
- Posts: 399
- Joined: Mon Feb 08, 2021 7:56 pm
- Location: Krefeld, Germany
- Has thanked: 189 times
- Been thanked: 221 times
- Contact:
Re: ESP32-CAM flash
Hi Rainer,
I am using the CAM firmware 1.43.5 with an M5Cam and some ESP32CAMs.
No seen such a problem until now.
Did you see that you can select the appropriate CAM- module from the listbox at the config-page?
I am using the CAM firmware 1.43.5 with an M5Cam and some ESP32CAMs.
No seen such a problem until now.
Did you see that you can select the appropriate CAM- module from the listbox at the config-page?
-
- Posts: 36
- Joined: Sat Feb 20, 2021 9:36 am
- Location: Sindelfingen, Germany
- Has thanked: 143 times
- Been thanked: 10 times
Re: ESP32-CAM flash
I am also using firmaware 1.43.5, Selection in the Toolkit was ESP CAM.
Is there also an option in the Config page of the module ?
Unfortunately I can´t check at the moment because I am not at home.
Is there also an option in the Config page of the module ?
Unfortunately I can´t check at the moment because I am not at home.
- PeterN
- Posts: 399
- Joined: Mon Feb 08, 2021 7:56 pm
- Location: Krefeld, Germany
- Has thanked: 189 times
- Been thanked: 221 times
- Contact:
Re: ESP32-CAM flash
You do not have the required permissions to view the files attached to this post.
-
- Posts: 36
- Joined: Sat Feb 20, 2021 9:36 am
- Location: Sindelfingen, Germany
- Has thanked: 143 times
- Been thanked: 10 times
Re: ESP32-CAM flash
Oh, I didn´t recognize that this is not only for attached displays.
So this is the very probable solution. I will try immediately when I am back.
Thanks a lot !
So this is the very probable solution. I will try immediately when I am back.
Thanks a lot !