I'm trying to reflash a Wemos D1Mini currently flashed with 1.37 Beta 1. In the web flasher, I click on connect and select the port. It says connected successfully, but I don't get the options to select the firmware and set the configuration.
If I try with an ESP32-S2Mini, I connect and get the expected choices.
What am I doing wrong?
Web flasher not showing firmware
-
cicciocb
- Site Admin
- Posts: 1989
- Joined: Mon Feb 03, 2020 1:15 pm
- Location: Toulouse
- Has thanked: 426 times
- Been thanked: 1329 times
- Contact:
Re: Web flasher not showing firmware
Connected successfully just mean that the serial port is open (I'll change this message because is very toxic 
)
Try to hold the boot button on the module while you connect it with the PC
)Try to hold the boot button on the module while you connect it with the PC
Re: Web flasher not showing firmware
The D1Mini doesn't have a boot button (as on the S2Mini), just a reset button. Flashing from the application (not the web) did not require that--but I'll pull pin 0 to ground when powering up and I'll see what happens.
That worked. D1Mini flashed Ok and reported its old fixed IP address. I connected to it and the original files are there. Thanks.
That worked. D1Mini flashed Ok and reported its old fixed IP address. I connected to it and the original files are there. Thanks.