Page 1 of 1
flashing with the tool kit
Posted: Sat Jan 06, 2024 4:47 pm
by TrevorB
Been away awhile and lot has happened
I would like to catch up slowly so far have not managed to use the old tool kit to flash a module "Flash Not Complete error"
I may have a faulty module although I have more than one with the same error.
I would like to start with installing the toolkit from scratch with the latest version
can I have a link/
Re: flashing with the tool kit
Posted: Sat Jan 06, 2024 6:50 pm
by BeanieBots
The toolkit is no longer supported.
It is now done via a web based installer.
[Local Link Removed for Guests]
Note: Does not work with Firefox.
Re: flashing with the tool kit
Posted: Sat Jan 06, 2024 8:25 pm
by TrevorB
Thanks Beaniebots
I was just trying to find the later tool kit and unzip it, which I have done and press the wasp button but alas its not there
I suspect I have some modules that dont fully flash for various reasons
In the new world of your link all four module never get past connecting (I suspect it time to by some replacement hardware)
Welcome to Annex RDS Web Installer
Connecting...
Connected successfully.
Try hard reset.
Connecting...
Connecting...
Connecting...
Connecting...
Connecting...
Re: flashing with the tool kit
Posted: Sun Jan 07, 2024 8:57 am
by MarioL
Hi,
my solution at connection problem 100% winner:
I set connection baudrate at 9600.
Re: flashing with the tool kit
Posted: Sun Jan 07, 2024 9:10 am
by cicciocb
And some modules require to put the module manually in programming mode:
This is the opinion of chatGPT
image.png