Local Time Server

If doesn't fit into any other category ....
Post Reply
User avatar
Electroguard
Posts: 855
Joined: Mon Feb 08, 2021 6:22 pm
Has thanked: 273 times
Been thanked: 321 times

Local Time Server

Post by Electroguard »

DATE - TIME timekeeper
The ESP module normally synchronises its date and time from either of two NTP time servers ("pool.ntp.org" and "time.nist.gov"). Optionally an alternative (eg: intranet) time server can be defined using the [CONFIG] page.
I'm sure I remember an NTP field in Config, but can't see it now... is it still possible to specify a local intranet time server somehow?
User avatar
cicciocb
Site Admin
Posts: 1989
Joined: Mon Feb 03, 2020 1:15 pm
Location: Toulouse
Has thanked: 426 times
Been thanked: 1329 times
Contact:

Re: Local Time Server

Post by cicciocb »

Yes but this feature has been remove, never used and never reported working :roll:
User avatar
Electroguard
Posts: 855
Joined: Mon Feb 08, 2021 6:22 pm
Has thanked: 273 times
Been thanked: 321 times

Re: Local Time Server

Post by Electroguard »

Not needed it before, but been having a lot of network problems in the last few weeks, so just set up NTP time server on linux to keep the isolated subnet device times in sync, but then found it was not possible for Annex to use it.

Easily fixable if the NTP defaults could be edited, so have raised a request for including them in Config page.
Post Reply