Will Annex32 run on this Pico form factor ESP32 board?
Will Annex32 run on this Pico form factor ESP32 board?
2MB flash, 8MB PSRAM https://www.cnx-software.com/2022/09/26 ... pi-pico-w/
- cicciocb
- Site Admin
- Posts: 2101
- Joined: Mon Feb 03, 2020 1:15 pm
- Location: Toulouse
- Has thanked: 450 times
- Been thanked: 1389 times
- Contact:
Re: Will Annex32 run on this Pico form factor ESP32 board?
Hi Lizby,
the ESP32-S3 is another chip with a different architecture so the actual annex32 firmware do not runs on it.
However, I implemented the support for this chip as well as for the other chips of the family but I miss the time to finish.
At the same time, the toolkit must be modified as the upload process is different for each chip.
However, the board that you propose do not have enough flash (only 2mb), at least 4mb are required.
the ESP32-S3 is another chip with a different architecture so the actual annex32 firmware do not runs on it.
However, I implemented the support for this chip as well as for the other chips of the family but I miss the time to finish.
At the same time, the toolkit must be modified as the upload process is different for each chip.
However, the board that you propose do not have enough flash (only 2mb), at least 4mb are required.
Re: Will Annex32 run on this Pico form factor ESP32 board?
Thanks--I feared it was short of the necessary flash. Wanted to check before purchasing.