BUT
Flashing 'Firmware only' proceeds with no error!
It's easy enough then to connect to the 192.146.4.1 address to set the network parameters and camera type.
I've tested the basic camera operations and all works OK. Working fine with SD card too. I haven't used the facial recognition features but as the firmware appears to be fully operational I'd expect no problems, unless it tries to take some previously unallocated FLASH.
Cicciocb, have I discovered something here or have you 'been there, done that' and I can experience problems down the line?
This is the bootup output :
Code: [Local Link Removed for Guests]
rst:0x1(OWRNRESET),boot:013(PIFST_FLASH_BOOT
lshrad err, 1000
t_mi.c371
st:x0(TWD_TCRSET),boot:0x13(SIFATFAHBO)
cnfgip 0, SPIWP:0xee
lkdv0x00,q_drv:0x0,ddv:x0,s_r:x00h_dv0x00,wp_drv:0x0
md:DO, clock div:
od:xfff0018,len:4
lad03ff0cln121
ho0tail 12 room
od:x0078000,len:920
o ail 12 room 4
lad04080400,len:635
nry0400b
P˕ initializing...
PSRAM enabled
module Type 201 SD_Card 1
Camera Enabled
OK
No SD cards found. Reverts to FFAT
AnnexCAM DET 1.43.5
(C) ciccioCB 2021
Personal use only, commercial use strictly prohibited
Chip revision 1 Freq 240
STARTING...
Connecting.......