OTA

Here you'll find the updated available
Post Reply
cicciocb
Site Admin
Posts: 311
Joined: Mon Feb 03, 2020 1:15 pm
Location: Toulouse
Has thanked: 85 times
Been thanked: 197 times
Contact:

OTA

Post by cicciocb »

This is a little procedure that shows how update a module using the OTA (Over The Air).

This example illustrate an ESP32 going from the version 1.43 to the version 1.43.4


Th first step is to run the AnnexToolkit
image.png


Select the OTA tab; by default the OTA server is stopped
image.png


Start the OTA server clicking on the button; Verify that the message "started" is shown
image.png


A web page is automatically shown;
this page reports all the URL that must be used for the different modules.
Copy the url for the ESP32 modules (highlighted text in the picture)
image.png


Open the web page of the module and select the Config page;
paste the url copied from the previous page in the ORA url field
Note that the actual version installed is the 1.43.
Click on Save and then on OTA Update
image.png


The Progress Bar will start to indicate the download process
image.png



When the process is over, the progress bar will reach the 100%
The process should take around 1 minute
image.png



Wait a little bit (~1 minute), the time required for storing the firmware inside the module;
refresh the module web page clicking on the Config tab
Check that the module shows the new version 1.43.4
image.png
You do not have the required permissions to view the files attached to this post.
Post Reply