Esp32 Cam Fehler bein Flashen

Recurrent H/W and software problems
Post Reply
Red Nose
Posts: 2
Joined: Sun Jan 02, 2022 1:38 pm

Esp32 Cam Fehler bein Flashen

Post by Red Nose »

Hallo,
mein Board wird nicht erkannt und beim Flashen kommt eine Fehlermeldung.
Hat jemand eine Idee?
Vielen Dank
You do not have the required permissions to view the files attached to this post.
User avatar
Electroguard
Posts: 835
Joined: Mon Feb 08, 2021 6:22 pm
Has thanked: 267 times
Been thanked: 317 times

Re: Esp32 Cam Fehler bein Flashen

Post by Electroguard »

Hi,
Make sure you have the correct ESP Tab selected in the Serial Flasher... eg: the ESP8266 default will fail with an error if trying to flash an ESP32 type device without selecting the appropriate device tab.

Drop the speed down in case you have a slow usb cable.
Check that com3 is the correct com port by unplugging the ESP device and re-running the flashing tool to check that com3 is no longer available.
If all seems correct, try reading the ESP parameters using the Blue button.
If you can READ the device ok, then you should be able to Flash the device ok.
Red Nose
Posts: 2
Joined: Sun Jan 02, 2022 1:38 pm

Re: Esp32 Cam Fehler bein Flashen

Post by Red Nose »

Hallo,
vielen Dank für die Hilfestellung.
Ich habe es gerade genauso wie vorher probiert und keine Veränderungen vorgenommen.
Das Board wurde wieder erkannt und ich konnte es auch mit Annex flashen.
Es ist manchmal seltsam warum es zu so einem Verhalten führt.
Nochmals besten Dank und viele Grüße!
User avatar
Electroguard
Posts: 835
Joined: Mon Feb 08, 2021 6:22 pm
Has thanked: 267 times
Been thanked: 317 times

Re: Esp32 Cam Fehler bein Flashen

Post by Electroguard »

As the english saying goes... "All's well that ends well"
Post Reply