Page 1 of 1

ESP32-CAM flash

Posted: Mon Sep 13, 2021 10:22 pm
by rmsta
Hello,
I just did "Flash firmware only". That worked, so I connected to 192.168.4.1 and set up the Config page as needed with Name and PW for
Station Mode. But the module never connected to the router and went back to AP Mode.
Trying with firmware+data for ESP32 (not CAM) the connection to the router worked immediately.
Is there a hint how to get the the module connected to router with ESP32-CAM firmware ?
Thanks a lot.
Rainer

Re: ESP32-CAM flash

Posted: Wed Sep 15, 2021 12:44 pm
by PeterN
Hi Rainer,

I am using the CAM firmware 1.43.5 with an M5Cam and some ESP32CAMs.
No seen such a problem until now.
Did you see that you can select the appropriate CAM- module from the listbox at the config-page?

Re: ESP32-CAM flash

Posted: Wed Sep 15, 2021 10:56 pm
by rmsta
I am also using firmaware 1.43.5, Selection in the Toolkit was ESP CAM.
Is there also an option in the Config page of the module ?
Unfortunately I can´t check at the moment because I am not at home.

Re: ESP32-CAM flash

Posted: Wed Sep 15, 2021 11:21 pm
by PeterN
5E786056-C405-4880-9124-8095C058D7A0.jpeg

Re: ESP32-CAM flash

Posted: Thu Sep 16, 2021 8:27 am
by rmsta
Oh, I didn´t recognize that this is not only for attached displays.
So this is the very probable solution. I will try immediately when I am back.
Thanks a lot !