ESP32-CAM with 8MB?

Annex for ESP32
User avatar
cicciocb
Site Admin
Posts: 1899
Joined: Mon Feb 03, 2020 1:15 pm
Location: Toulouse
Has thanked: 407 times
Been thanked: 1269 times
Contact:

Re: ESP32-CAM with 8MB?

Post by cicciocb »

[Local Link Removed for Guests] wrote: [Local Link Removed for Guests]Fri Sep 16, 2022 3:54 pm OK found the answer here https://sites.google.com/site/annexwifi ... s/webpages
still dont know about the LED on tho' hope it don't burn out :|
The led is full bright because this pin is used for the CS signal for the SDCARD.
You certainly flashed the Annex32 firmware instead of the AnnexCAM firmware that maps the right pins and enable the use of the camera.
oldbiddy
Posts: 5
Joined: Mon Sep 05, 2022 4:19 pm
Has thanked: 1 time

Re: ESP32-CAM with 8MB?

Post by oldbiddy »

thanks for that sorted it by changing the module in config
Jo.2a
Posts: 9
Joined: Thu Feb 09, 2023 2:19 pm

Re: ESP32-CAM with 8MB?

Post by Jo.2a »

Hello
I flash an ESP32 CAM and i install a SD CARD (8 Mb).
To write in a file, it's possible to make the difference from the RAM of the ESP 32 and the RAM of the SD CARD ?
Thanks
Jo (From FRANCE)
User avatar
cicciocb
Site Admin
Posts: 1899
Joined: Mon Feb 03, 2020 1:15 pm
Location: Toulouse
Has thanked: 407 times
Been thanked: 1269 times
Contact:

Re: ESP32-CAM with 8MB?

Post by cicciocb »

[Local Link Removed for Guests] wrote: [Local Link Removed for Guests]Sun Nov 05, 2023 12:25 pm Hello
I flash an ESP32 CAM and i install a SD CARD (8 Mb).
To write in a file, it's possible to make the difference from the RAM of the ESP 32 and the RAM of the SD CARD ?
Thanks
Jo (From FRANCE)
When the SDCARD is installed, the files are always written in the SDCARD as the internal flash is disabled
Jo.2a
Posts: 9
Joined: Thu Feb 09, 2023 2:19 pm

Re: ESP32-CAM with 8MB?

Post by Jo.2a »

Thanks
Iwill try as soon as possible
Jo
Post Reply