how to catch the messages which annex send over the console whith annex basic ?
i like to get all the statusmessages on annex itself.
i mean all messages which annex sends intern to the console.
i2s stop, buffered prefilled , and so on .
thx
catch output messages from Annex in Annex
- PeterN
- Posts: 384
- Joined: Mon Feb 08, 2021 7:56 pm
- Location: Krefeld, Germany
- Has thanked: 177 times
- Been thanked: 214 times
- Contact:
Re: catch output messages from Annex in Annex
Hi panno,
this may be very brutal and hardware oriented ... but you could connect the TX pin with the RX pin
this may be very brutal and hardware oriented ... but you could connect the TX pin with the RX pin
- Electroguard
- Posts: 852
- Joined: Mon Feb 08, 2021 6:22 pm
- Has thanked: 273 times
- Been thanked: 321 times
Re: catch output messages from Annex in Annex
It's only hardware serial out for any connected serial monitoring device, so you could define Serial2 and connect hardware serial(1) TX out to the software serial2 RX in, then use ONSERIAL2 to branch and do whatever you want.