Page 2 of 2

Re: AnnexCam in 4MB!?

Posted: Fri Oct 22, 2021 10:18 am
by AndyGadget
If you have a 3D printer, I've posted a jig to make adjusting the ESP32-CAM focus easier on Thingiverse : https://www.thingiverse.com/thing:5027224
Not necessary if it's in a case which secures the lens assembly, but useful if you're adjusting them in the 'raw' state.

Re: AnnexCam in 4MB!?

Posted: Fri Oct 22, 2021 10:23 am
by PeterN
Thanks, that is a good helper! Until now I took double sided adhesive tape and glued the camera at the SD_card housing

Re: AnnexCam in 4MB!?

Posted: Fri Oct 22, 2021 11:00 am
by PeterN
That was one of the results of my experiments with face detection and recognition:


Re: AnnexCam in 4MB!?

Posted: Sat Oct 23, 2021 12:18 am
by PANNO2
thx for your Support and the hint with adhesive vapor. :D