If you have a 3D printer, I've posted a jig to make adjusting the ESP32-CAM focus easier on Thingiverse : https://www.thingiverse.com/thing:5027224
Not necessary if it's in a case which secures the lens assembly, but useful if you're adjusting them in the 'raw' state.
AnnexCam in 4MB!?
-
- Posts: 222
- Joined: Mon Feb 15, 2021 1:44 pm
- Has thanked: 120 times
- Been thanked: 132 times
- PeterN
- Posts: 366
- Joined: Mon Feb 08, 2021 7:56 pm
- Location: Krefeld, Germany
- Has thanked: 171 times
- Been thanked: 203 times
- Contact:
Re: AnnexCam in 4MB!?
Thanks, that is a good helper! Until now I took double sided adhesive tape and glued the camera at the SD_card housing
- PeterN
- Posts: 366
- Joined: Mon Feb 08, 2021 7:56 pm
- Location: Krefeld, Germany
- Has thanked: 171 times
- Been thanked: 203 times
- Contact:
Re: AnnexCam in 4MB!?
That was one of the results of my experiments with face detection and recognition: