AnnexCam in 4MB!?

If doesn't fit into any other category ....
AndyGadget
Posts: 222
Joined: Mon Feb 15, 2021 1:44 pm
Has thanked: 120 times
Been thanked: 132 times

Re: AnnexCam in 4MB!?

Post by AndyGadget »

If you have a 3D printer, I've posted a jig to make adjusting the ESP32-CAM focus easier on Thingiverse : https://www.thingiverse.com/thing:5027224
Not necessary if it's in a case which secures the lens assembly, but useful if you're adjusting them in the 'raw' state.
User avatar
PeterN
Posts: 366
Joined: Mon Feb 08, 2021 7:56 pm
Location: Krefeld, Germany
Has thanked: 171 times
Been thanked: 203 times
Contact:

Re: AnnexCam in 4MB!?

Post by PeterN »

Thanks, that is a good helper! Until now I took double sided adhesive tape and glued the camera at the SD_card housing
User avatar
PeterN
Posts: 366
Joined: Mon Feb 08, 2021 7:56 pm
Location: Krefeld, Germany
Has thanked: 171 times
Been thanked: 203 times
Contact:

Re: AnnexCam in 4MB!?

Post by PeterN »

That was one of the results of my experiments with face detection and recognition:

PANNO2
Posts: 51
Joined: Tue Jun 08, 2021 6:26 pm
Has thanked: 47 times
Been thanked: 3 times

Re: AnnexCam in 4MB!?

Post by PANNO2 »

thx for your Support and the hint with adhesive vapor. :D
Post Reply